OpenLegislation

Division 2.2

Original text. Later amendments are not shown.

For a system, component or separate technical unit as listed in table 1 the manufacturer shall complete the applicable appendix to this Annex.

In addition to the Annexes mentioned in table 1, the systems, components and separate technical units shall comply with the following requirements:

  • arrangements for type-approval procedures (Annex III of Commission Delegated Regulation (EU) No 44/2014)

  • conformity of production (CoP) (Annex IV of Delegated Regulation (EU) No 44/2014)

  • access to repair and maintenance information (Annex XV of Delegated Regulation (EU) No 44/2014)

Table 1

Lists of systems, components and separate technical units which may be subject to an EU type-approval

LIST I — Environmental and propulsion unit performance requirements
AppendixSystem or component/separate technical unit (STU)Commission Delegated Regulation (EU) No 134/2014 Annex numberAs amended by and/or at the stage of implementation
1System: tailpipe pollution-control systemII, III, V, VI
2System: crankcase and evaporative emissionsIV, V
3System: environmental and functional on-board diagnostic (OBD)

VIII

(and Annex XII to Commission Delegated Regulation (EU) No 44/2014)

4System: sound levelIX
5System: propulsion unit performanceX
F15a System: maximum torque and a maximum net power of a propulsion unit

X

Appendix 2

6STU: pollution-control deviceII, III, IV, V, VI
7STU: noise-abatement deviceIX
8STU: exhaust device (pollution-control device and noise-abatement device)II, III, V, VI, IX
LIST II — Vehicle functional safety requirements
AppendixSystem or component/separate technical unit (STU)Commission Delegated Regulation (EU) No 3/2014 Annex numberAs amended by and/or at the stage of implementation
8a System: installation of audible warning devices II
9System: brakingIII
9a System: installation of glazing, windscreen wipers and defrosting and demisting devices VII
9b System: identification of controls, tell-tales and indicators VIII
10System: installation of lighting and light-signalling devicesIX
11System: Roll-over protective structure (ROPS)XI
11a System: safety belt anchorages XII
11b System: steer-ability, cornering properties and turn ability XIV
12System: installation of tyresXV
13Component: audible warning deviceII
13a System: vehicle occupant protection, including interior fittings, head restraint and vehicle doors XVII
14Component/STU: non-glazing front windscreenVII
15Component/STU: windscreen washer deviceVII
16Component/STU: rearward visibility deviceX
17STU: safety beltsXII
18Component/STU: seating position (saddle/seat)XIII
LIST III — Vehicle construction and general type-approval requirements
AppendixSystem or component/separate technical unit (STU)Commission Delegated Regulation (EU) No 44/2014 Annex numberAs amended by and/or at the stage of implementation
19STU: trailer coupling deviceV
20STU: devices to prevent unauthorised useVI
20a STU: fuel tank IX
21STU: passenger handholdsXIII
22STU: footrestsXIII
23STU: side-car

VIII, XI, XIII;

(and Annexes III, V, VII, IX, X, XII, XIII, XIV, XV, XVII and XIX to Commission Delegated Regulation (EU) No 3/2014)

Annotations

Textual amendments

F1

Inserted by Commission Implementing Regulation (EU) 2016/1825 of 6 September 2016 amending Implementing Regulation (EU) No 901/2014 with regard to the administrative requirements for the approval and market surveillance of two- or three-wheel vehicles and quadricycles (Text with EEA relevance).

Notes on Attachment

Textual amendments

F1

Substituted by Commission Implementing Regulation (EU) 2016/1825 of 6 September 2016 amending Implementing Regulation (EU) No 901/2014 with regard to the administrative requirements for the approval and market surveillance of two- or three-wheel vehicles and quadricycles (Text with EEA relevance).